Constructing Rings

You can construct a Ring of any thickness or size by specifying the diameters of two concentric Circles. The area between the Circles is filled. A filled Circle has an inner diameter of zero.

To construct Rings and filled Circles:

1. Click Draw > Ring (or type Ring).
2. Do one of the following:
   • On the menu, click Draw > Ring.
   • Type Ring.
3. In the graphics area, specify the inner diameter or enter a value. For a filled circle, enter 0.
4. Specify the outer diameter, or enter a value.
5. In the graphics area, specify the center point of the Ring.
6. (Optional) Continue to specify the centers of identical Rings
7. Press Enter to end the command.

Access

Command: Ring

Menu: Draw > Ring

Ribbon: Home > Ring