Editing BlockAttribute Values In-place

Use the EditIpBlockAttribute command to edit the values of BlockAttributes in-place.

To edit BlockAttribute values:

1. Type EditIpBlockAttribute at the command prompt.
2. In the graphics area, specify a BlockAttribute.

   The SimpleNote Formatting pop-up toolbar displays.

3. Edit the BlockAttribute value in place.
4. Edit the BlockAttribute value in place:
   • If the selected entity is a singleline BlockAttribute, the SimpleNote Formatting pop-up toolbar displays.
   • If the selected entity is a multiline BlockAttribute, the Multiline BlockAttribute Formatting pop-up toolbar displays.
5. Close the toolbar.

Access

Command: EditIpBlockAttribute