3D Viewing Using Continuous Orbit

Use the RollViewContinuous command to rotate the view in 3D with continuous motion about a pivot point.

To view the model in 3D using continuous Orbit:

1. Do one of the following:
   • On the menu, click View > 3D Orbit > Continuous Orbit.
   • On the ribbon, click View > Render > Continuous Orbit .
   • Type RollViewContinuous.
   • On the toolbar, click 3D Orbit > Continuous Orbit .
2. In the graphics area, drag the pointer.

   A green pivot point  appears where you clicked and is the center for the rotation.

3. In the graphics area, drag the pointer.

   A pivot point  appears where you clicked and is the center for the rotation.

4. Release the mouse button.

   The orbit view keeps spins in the direction of the drag.

   Note: The arcball feature is not available in this Constrained Orbit mode.

5. Press Esc or Enter to exit Constrained Orbit mode.

Access

Command: RollViewContinuous

Menu: View > 3D Orbit > Continuous Orbit

Ribbon: View > Render > Continuous Orbit

Toolbar: Continuous Orbit