3D Viewing Using Horizontal Orbit

Use the RollViewHorizontal command to swivel the view of your model horizontally about an imaginary vertical axis.

To view the model in 3D using horizontal orbit:

1. Do one of the following:
   • On the menu, click View > 3D Orbit > Horizontal Orbit.
   • On the ribbon, click View > Render > Horizontal Orbit .
   • Type RollViewHorizontal.
   • On the toolbar, click 3D Orbit > Horizontal Orbit .
2. In the graphics area, drag the pointer.

   A green pivot point  appears in the center of the model. If you selected entities before you entered Constrained Orbit mode, the pivot point appears at the center of the selected entities.

   A pivot point  appears in the center of the model. If you selected entities before you entered Constrained Orbit mode, the pivot point appears at the center of the selected entities.

   Note: The arcball feature is not available in this Constrained Orbit mode.

3. Press Esc or Enter to exit Constrained Orbit mode.

Access

Command: RollViewHorizontal

Menu: View > 3D Orbit > Horizontal Orbit

Ribbon: View > Render > Horizontal Orbit

Toolbar: Horizontal Orbit